$ 29.99
0 0 0
The exterior plastic trim parts of a car are exposed to many damaging environmental impacts. UV-radiation and heat can damage the plastic trim, turning it grey and making it brittle. Frost, salt, strong and aggressive cleaners, acid rain as well as mechanical abrasion have an extremely detrimental effect on plastic...

The exterior plastic trim parts of a car are exposed to many damaging environmental impacts. UV-radiation and heat can damage the plastic trim, turning it grey and making it brittle. Frost, salt, strong and aggressive cleaners, acid rain as well as mechanical abrasion have an extremely detrimental effect on plastic parts, and cause them deteriorate quickly.

The special, deeply-penetrating ingredients of Nanolex Trim Rejuvenator ensure that the trim does not fade or become brittle. The typical effects of weathering and greying are also prevented. Nanolex Trim Rejuvantor cleanses gently and adds durability, plus it penetrates the surfaces easily and quickly without adding a greasy finish or leaving an artificial shine.

With proper maintenance (LINK to maintenance instructions!) Nanolex Trim Rejuvenator will last approximately 15000 km on the surfaces it was applied to. (LINK to manual(S))

Nanolex Trim Rejuvantor was developed, tested and manufactured in Germany. 

Size: 200 ml and 1000 ml

Directions
How To Use Nanolex Trim Rejuvenator
This product can be stored for up to 24 months (in a dry, temperature stable environment)
Processing temperature: 5-30°C - Avoid direct sunlight and/or high air humidity.
IMPORTANT: Before you use a Nanolex Car Care product please make sure you wear suitable protection
gear – we always recommend to use Latex-or Nitril gloves to make sure your hands are protected from
any possible damage to your skin.
1. Nanolex Trim Rejuvenator can be applied to all exterior plastic trim. The surface must be dry and free of contamination and dust. We recommend to use Nanolex EX to assure that all contamination is removed completely.
2. Nanolex Trim Rejuvenator should be applied very sparingly with a lint free tissue/applicator pad etc. to
create an even but very thin layer of coating. The surface must be covered completely. After
the application excess material should be removed by simply wiping it off with a lint free microfiber cloth,
applying medium pressure.
3. Directly after polishing the sealant is dry and the surface can be touched. At normal ambient
temperature the sealant is completely cured after approximately 2 minutes.
Please read the separate information on how to clean your car after a treatment with Nanolex
sealants.
Just added to your wishlist:
My Wishlist
Just added to your cart:
My Cart